} // namespace
Mixer::Mixer(const QSurfaceFormat &format, unsigned num_cards)
- : httpd("test.ts", WIDTH, HEIGHT),
+ : httpd(LOCAL_DUMP_FILE_NAME, WIDTH, HEIGHT),
num_cards(num_cards),
mixer_surface(create_surface(format)),
h264_encoder_surface(create_surface(format)),
// hlen=16 is pretty low quality, but we use quite a bit of CPU otherwise,
// and there's a limit to how important the peak meter is.
peak_resampler.setup(OUTPUT_FREQUENCY, OUTPUT_FREQUENCY * 4, /*num_channels=*/2, /*hlen=*/16);
+
+ alsa.reset(new ALSAOutput(OUTPUT_FREQUENCY, /*num_channels=*/2));
}
Mixer::~Mixer()
}
cards[card_index].usb->stop_dequeue_thread();
}
+
+ h264_encoder.reset(nullptr);
}
namespace {
// float limiter_att, compressor_att;
- // Then a limiter at +0 dB (so, -14 dBFS) to take out the worst peaks only.
- // Note that since ratio is not infinite, we could go slightly higher than this.
- // Probably more tuning is warranted here.
- {
- float threshold = pow(10.0f, (ref_level_dbfs + 0.0f) / 20.0f); // +0 dB.
- float ratio = 30.0f;
- float attack_time = 0.0f; // Instant.
- float release_time = 0.005f;
- float makeup_gain = 1.0f; // 0 dB.
- limiter.process(samples_out.data(), samples_out.size() / 2, threshold, ratio, attack_time, release_time, makeup_gain);
-// limiter_att = limiter.get_attenuation();
- }
-
- // Finally, the real compressor.
- {
- float threshold = pow(10.0f, (ref_level_dbfs - 12.0f) / 20.0f); // -12 dB.
+ // The real compressor.
+ if (compressor_enabled) {
+ float threshold = pow(10.0f, compressor_threshold_dbfs / 20.0f);
float ratio = 20.0f;
float attack_time = 0.005f;
float release_time = 0.040f;
// compressor_att = compressor.get_attenuation();
}
+ // Finally a limiter at -4 dB (so, -10 dBFS) to take out the worst peaks only.
+ // Note that since ratio is not infinite, we could go slightly higher than this.
+ if (limiter_enabled) {
+ float threshold = pow(10.0f, limiter_threshold_dbfs / 20.0f);
+ float ratio = 30.0f;
+ float attack_time = 0.0f; // Instant.
+ float release_time = 0.020f;
+ float makeup_gain = 1.0f; // 0 dB.
+ limiter.process(samples_out.data(), samples_out.size() / 2, threshold, ratio, attack_time, release_time, makeup_gain);
+// limiter_att = limiter.get_attenuation();
+ }
+
// printf("limiter=%+5.1f compressor=%+5.1f\n", 20.0*log10(limiter_att), 20.0*log10(compressor_att));
// Upsample 4x to find interpolated peak.
float *ptrs[] = { left.data(), right.data() };
r128.process(left.size(), ptrs);
- // Actually add the samples to the output.
+ // Send the samples to the sound card.
+ if (alsa) {
+ alsa->write(samples_out);
+ }
+
+ // And finally add them to the output.
h264_encoder->add_audio(pts_int, move(samples_out));
}