**Simple** audio mode is the default, and was the only mode available
up until Nageru 1.4.0. Despite its name, it contains a powerful
audio processing chain; however, in many cases, you won't need to
**Simple** audio mode is the default, and was the only mode available
up until Nageru 1.4.0. Despite its name, it contains a powerful
audio processing chain; however, in many cases, you won't need to
Simple mode allows input from only a single source, and that source
has to be one of the capture cards. (You choose which one by right-clicking
Simple mode allows input from only a single source, and that source
has to be one of the capture cards. (You choose which one by right-clicking
The audio strip contains controls for the processing chain for the audio from
start to end, left to right. Note that by default, everything is enabled;
The audio strip contains controls for the processing chain for the audio from
start to end, left to right. Note that by default, everything is enabled;
want 1:1 into the stream, you can start Nageru with the “--flat-audio”
flag, that instead starts with everything disabled.
want 1:1 into the stream, you can start Nageru with the “--flat-audio”
flag, that instead starts with everything disabled.
effects are separate per-bus and the remaining are applied
after the mix. (More on this below.) The mastering section begins
with a **limiter**, basically a compressor with very high ratio.
effects are separate per-bus and the remaining are applied
after the mix. (More on this below.) The mastering section begins
with a **limiter**, basically a compressor with very high ratio.
that got through the other compressors—a classic example is a
speaker suddenly coughing, or a very loud bass drum. This prevents
both clipping and blowing out the speakers' ears.
that got through the other compressors—a classic example is a
speaker suddenly coughing, or a very loud bass drum. This prevents
both clipping and blowing out the speakers' ears.
you can use the + button to add a new bus, and the - button to remove
the currently selected one (you select by clicking on it). The up and
down buttons rearrange the order by moving the currently selected bus
you can use the + button to add a new bus, and the - button to remove
the currently selected one (you select by clicking on it). The up and
down buttons rearrange the order by moving the currently selected bus
Because mappings can be tedious to setup, you wouldn't want to set up
a complicated one every time you started Nageru. Therefore, mappings
Because mappings can be tedious to setup, you wouldn't want to set up
a complicated one every time you started Nageru. Therefore, mappings
you don't want to know loudness; you want to know recording levels,
so this is a peak meter, *not* a loudness meter. (There's some holdoff
so you can see the actual peaks over a short period.) In particular,
you don't want to know loudness; you want to know recording levels,
so this is a peak meter, *not* a loudness meter. (There's some holdoff
so you can see the actual peaks over a short period.) In particular,
Unless you have a reference sheet for your MIDI controller, specifying which
controller and number numbers the different physical knobs and faders
Unless you have a reference sheet for your MIDI controller, specifying which
controller and number numbers the different physical knobs and faders
(Actually, even with a reference sheet, it probably is.) Thus, the preferred
way is by autosensing; simply select the given mapping with the mouse
and use the control you want to bind it to, and Nageru automatically
(Actually, even with a reference sheet, it probably is.) Thus, the preferred
way is by autosensing; simply select the given mapping with the mouse
and use the control you want to bind it to, and Nageru automatically