@end example
@item -dframes @var{number} (@emph{output})
-Set the number of data frames to output. This is an alias for @code{-frames:d}.
+Set the number of data frames to output. This is an obsolete alias for
+@code{-frames:d}, which you should use instead.
@item -frames[:@var{stream_specifier}] @var{framecount} (@emph{output,per-stream})
Stop writing to the stream after @var{framecount} frames.
@table @option
@item -vframes @var{number} (@emph{output})
-Set the number of video frames to output. This is an alias for @code{-frames:v}.
+Set the number of video frames to output. This is an obsolete alias for
+@code{-frames:v}, which you should use instead.
@item -r[:@var{stream_specifier}] @var{fps} (@emph{input/output,per-stream})
Set frame rate (Hz value, fraction or abbreviation).
@table @option
@item -aframes @var{number} (@emph{output})
-Set the number of audio frames to output. This is an alias for @code{-frames:a}.
+Set the number of audio frames to output. This is an obsolete alias for
+@code{-frames:a}, which you should use instead.
@item -ar[:@var{stream_specifier}] @var{freq} (@emph{input/output,per-stream})
Set the audio sampling frequency. For output streams it is set by
default to the frequency of the corresponding input stream. For input
etc. Images will be rescaled to fit the new WxH values.
If you want to extract just a limited number of frames, you can use the
-above command in combination with the -vframes or -t option, or in
-combination with -ss to start extracting from a certain point in time.
+above command in combination with the @code{-frames:v} or @code{-t} option,
+or in combination with -ss to start extracting from a certain point in time.
For creating a video from many images:
@example