Write about CasparCG integration.

[nageru-docs] / audio.rst

diff --git a/audio.rst b/audio.rst
index 8aa2078b6dbbea43b1684943189960c7db2cc344..58e3ed07a71df0f3d11c2dc144e8f5ac1abfe4c6 100644 (file)
--- a/audio.rst
+++ b/audio.rst
@@ -169,7 +169,7 @@ the distinction won't matter, but for multichannel, the previous
 effects are separate per-bus and the remaining are applied
 after the mix. (More on this below.) The mastering section begins
 with a **limiter**, basically a compressor with very high ratio.
-It's there as an emergency brake for really loud compressors
+It's there as an emergency brake for really loud sounds
 that got through the other compressors—a classic example is a
 speaker suddenly coughing, or a very loud bass drum. This prevents
 both clipping and blowing out the speakers' ears.
@@ -220,7 +220,8 @@ The input mapping dialog should be pretty much self-explanatory;
 you can use the + button to add a new bus, and the - button to remove
 the currently selected one (you select by clicking on it). The up and
 down buttons rearrange the order by moving the currently selected bus
-up or down, if possible.
+up or down, if possible. Note that you can create a mono bus by
+assigning the same input channel to the left and right inputs.
 
 Because mappings can be tedious to setup, you wouldn't want to set up
 a complicated one every time you started Nageru. Therefore, mappings
@@ -284,7 +285,7 @@ effect as pulling the fader all the way down, ie., it will make the bus
 go all silent.
 
 Then there's the **peak meter** to the left of that. For each bus, unlike
-for the meters used for mastering (see :ref:`audio meters`),
+for the meters used for mastering (see :ref:`audio-meters`),
 you don't want to know loudness; you want to know recording levels,
 so this is a peak meter, *not* a loudness meter. (There's some holdoff
 so you can see the actual peaks over a short period.) In particular,